Sioux Chief 8822 Titan 2 Mechanical Test Plug

Sioux Chief 8822 Titan 2 Mechanical Test Plug

The Sioux Chief 8822 Titan 2 Mechanical Test Plug is a rough-in plumbing accessory built to temporarily seal an open pipe end while a drain, waste, and vent (DWV) system is pressure- or water-tested ahead of rough-in inspection. As part of the Sioux Chief Titan 2 mechanical test plug line, this plug is manufactured in the United States and is not intended for permanent use — it is installed only for the duration of the test, then removed once the line has held pressure and passed inspection. Plumbers and contractors use plugs like this one to isolate a section of DWV pipe, confirm there are no leaks at the joints, and sign off on rough-in before drywall, flooring, or concrete closes the line in for good. It ships packaged 10 EA per unit, giving a crew a working supply of test plugs to carry on the truck or keep stocked in the shop for repeat use across multiple rough-in tests and jobsites.

Key Features

• Mechanical Test Plug: Mechanically seals an open DWV pipe end so the line can be pressurized with air or filled with water for a leak test before the wall or floor is closed in.
• Titan 2 Series: Part of the Sioux Chief Titan 2 line of mechanical test plugs used to verify that rough-in drain, waste, and vent lines are ready for inspection.
• Temporary Use Only: Not intended for permanent installation — install only for the duration of testing and remove once the line has passed inspection so the permanent fittings can be completed.
• Made in the USA: Manufactured in the United States, supporting consistent, domestically produced rough-in test equipment.
• Jobsite Packaging: Packaged 10 EA per pack so plumbers and contractors can keep a working supply of test plugs on hand for multiple rough-in tests across a jobsite or from the truck without reordering after every job.

Technical Specifications

• Country of Origin: United States
• Packaging: 10 EA per pack

Typical Applications

• Drain, Waste & Vent (DWV) Rough-In Pressure Testing
• Pre-Inspection Leak Testing on New Construction
• Temporary Pipe-End Sealing During Rough-In
• Residential and Commercial Plumbing Rough-In
• Renovation Work Requiring Line Re-Test Before Close-In
• Code-Compliance Verification Prior to Covering DWV Lines

Why Sioux Chief?

Sioux Chief builds rough-in plumbing products that professional plumbers rely on to get a job through inspection the first time. The Titan 2 Mechanical Test Plug is manufactured in the United States and purpose-built as a temporary test fitting rather than a permanent component, giving contractors a straightforward, dedicated way to pressure- or water-test DWV lines before they are permanently closed in behind a wall or under a floor. Keeping a stock of these plugs on the truck helps a crew move from rough-in to inspection to close-in without delay.