You may also like
Altronix AL125ULP Power Supply/Charger, 24VAC, 40VA from UL Listed Class 2 Transformer, 2 PTC Outputs, 12VDC at 1A, 24VDC at 0.5A, Grey EnclosureIncludes Plug-in Transformer
Model: ALT-AL125ULP
Power Supply/Charger, 24VAC, 40VA from UL Listed Class 2 Transformer, 2 PTC Outputs, 12VDC at 1A, 24VDC at 0.5A, Grey EnclosureIncludes Plug-in Transformer
AL125ULP is a Two (2) Output Switching...
Altronix
$250.60
$229.96
Altronix SMP3ET High Current Power Supply/Charger, 16VDC Input from TP1640 Plug-in Transformer, 6/12VDC at 2.5A Output
Model: ALT-SMP3ET
Power Supply/Charger, Input 115VAC 60Hz at 3.5A, 8 Fused Outputs, 12/24VDC at 6A, Grey Enclosure
AL600ULPD8 is a multi-output power supply/charger that converts a 115VAC, 60Hz input into eight (8)...
Altronix
$127.79
Stanley 0400-011 Power Supply, Plug-In Transformer, 12VDC/1A/120VAC
Manufacturer Resources
Product Specs
- Product Group:
- Electronic Access Controls
- Product Subgroup:
- Parts and Accessories
- Product Type:
- Transformer
- Subcategory:
- Accessories
- Commercial/Residential:
- Commercial
- Parts and Accessories Type:
- Installation Accessories
- Product Attribute:
- Parts and Accessories
- Product Voltage:
- 12VDC/1A/120VAC
- Product Category:
- Window Hardware
- Department:
- Door Hardware
Stanley Security 0400-011 – Frequently Asked Questions
1) What voltage and amperage does the Stanley 0400-011 plug-in transformer put out?
The 0400-011 takes 120VAC input and puts out 12VDC at 1 amp. That DC output matters: a device that calls for 12VAC will not run correctly off it, and a 12VDC load drawing more than 1 amp needs a larger supply.
2) My 12VDC maglock or strike draws more than 1 amp. What transformer should I use instead of the Stanley 0400-011?
Step up to the DynaLock 5313, a plug-in 120VAC to 12VDC transformer rated 3 amps. The Stanley 0400-011 tops out at 1 amp on the DC side, so anything above that (multiple strikes on one supply, or a maglock plus a reader) should go on the larger unit.
3) Does the Stanley 0400-011 transformer hard-wire, or does it plug into a wall outlet?
It is a plug-in type, so it goes into a standard 120V receptacle rather than being wired into a junction box. If your install has no outlet at the door and you need to land line voltage in an enclosure or on a screw-mount plate, an open-frame unit like the DynaLock 5212 or the MS Sedco 12024 is the form factor you want.
4) Is the Stanley 0400-011 transformer rated for commercial access control work?
Yes, it is a commercial-duty unit, sold as an installation accessory for electronic access control. It is the power source for the door device, not the lock or reader itself, so it gets ordered alongside the hardware rather than in place of it.
5) My access control board needs 24V. Will the Stanley 0400-011 power it?
No. The 0400-011 is a 12V unit only. For a 24VAC load, the MS Sedco 12024 is an open-frame 120V to 24VAC screw-mount transformer.
6) I have an AC transformer already at the door but my strike needs DC. Do I have to replace the transformer?
Not necessarily. A silicon rectifier such as the Trine SR-1 converts an existing AC supply to DC at the device. Swapping to the Stanley 0400-011 is the cleaner route if you are replacing the supply anyway, since it delivers 12VDC at 1 amp straight from the receptacle.
7) What transformer feeds a 24 volt door device instead of a 12 volt one?
The MS Sedco 12024 is an open frame 24V AC transformer that steps 120V down to 24V and mounts by screw. The Stanley 0400-011 is a 12VDC/1A/120VAC unit, so it cannot feed a 24 volt device. Automatic door operators and some sensors and actuators run at 24 volts; verify the voltage and the AC or DC requirement stamped on the device before ordering either one.
8) Is there more than one version of the Stanley 0400-011 to choose from when ordering?
One configuration only: 12VDC/1A/120VAC. There is no voltage or amperage choice to make on the order, so match your device's draw to that 1 amp ceiling before you buy.
How fast can I get the Stanley Security 0400-011 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Stanley Security 0400-011 come with a warranty?
Absolutely. The Stanley Security 0400-011 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Stanley Security 0400-011?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Stanley Security 0400-011 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.