Viega 26045 MegaPress reducer Smart Connect technology Carbon steel, 2'' x 1-1/2''

FTG x P describes the two ends of the Viega 26045 MegaPress reducer: the FTG end is sized to slip into the press socket of another 2 inch MegaPress fitting, while the P end is a 1-1/2 inch press socket that accepts pipe. So it steps 2 inch down to 1-1/2 inch while mating fitting-to-fitting on the large side instead of needing an extra length of 2 inch pipe.

The 26045 reducer is carbon steel, which is the MegaPress material intended for use on black iron and carbon steel pipe systems rather than copper or stainless lines. Match it to Schedule steel pipe of the stated 2 inch and 1-1/2 inch sizes.

Yes. A press fitting like the 26045 relies on a clean, square, deburred pipe end seated fully into the 1-1/2 inch press socket, with an insertion mark so you can verify full depth before you press. Smart Connect is a feature that helps identify an unpressed connection during pressure testing, not a substitute for correct pipe prep.

A press reducer like the 26045 is the choice when you want no threading, no cutting oil, and no flame on the job, which matters in occupied buildings and ceilings. A threaded reducer still makes sense when you are tying into existing threaded nipples or valves, or working on pipe you cannot get a press jaw around. The press route needs a tool and the correct 2 inch and 1-1/2 inch jaws on hand.

It weighs 1.289 lbs and is made in Germany. The weight matters when you are hanging a reducing transition on an unsupported branch, since carbon steel fittings plus pipe fill add up fast on long horizontal runs.