American Standard 24 x 76-Inch Height Frameless Shower Screen - AMS-AM00824400

The 24 x 76-inch screen is a stationary panel recommended for a 48-inch (1524 mm) opening. It fills roughly half the opening and leaves the rest as a walk-in entry, so there is no door and no swing clearance to plan for. If your opening is much narrower or wider than 48 inches, the proportions won't work out the way the screen is intended.

You need at least 1 inch (25 mm) of threshold width to land the bottom U-channel. Measure the flat top of your curb or threshold before ordering. A narrow tiled curb or a bullnose edge that leaves less than an inch of bearing surface will not take the channel properly, and that is the detail that most often stops this install.

Fixed panel. It is a stationary screen with no hinge, no roller track, and no moving parts, so you walk around the open end rather than through a door. If you need the opening fully closed off, this is the wrong product type and you want a hinged or sliding enclosure instead.

Two mounting points: a U-channel that runs along the bottom on the threshold, and a metal glass clamp at the top against the wall. There is no header track across the opening and no side jamb on the open edge, which is what gives the frameless look. Plan the top clamp into solid blocking or a stud, since it carries the panel load.

Overall height is 76 inches (1930 mm), measured from the threshold up. On a standard 8-foot ceiling that leaves open space above the panel, which is normal for a walk-in screen and helps the shower vent. Confirm your shower walls are tiled at least to 76 inches so the top clamp lands on finished surface.

The screen is rated for shower and tub applications, so a tub installation is within its intended use. The limiting factor is the tub deck: you still need a full 1 inch (25 mm) of flat width for the bottom U-channel, and the 76-inch height is measured from wherever the channel sits, so on a tub rim the panel will finish higher off the floor than it would on a curb.

Silver Shine is the finish offered, on anodized aluminum hardware (part number AM00824400.213). Anodized aluminum rather than plated steel matters in a wet zone, and it pairs cleanly with chrome or polished nickel valve trim already in most bathrooms.