American Standard 26.77-in x 15.85-in Stainless Steel Sink Grid - AMS-7435000

The 7435000 grid is built for American Standard sink models 20SB.332211C.075 and 20SB.332211L.075, and it will drop into any bowl with the same interior dimensions. It is not a universal grid, so measure your bowl before ordering: the grid needs a bowl that clears roughly 27-3/8 inches front to back on its long axis.

No, and that is the point of the design. The 7435000 grid has an offset drain cutout to match the offset drain location in the sinks it is made for. If your bowl has a center drain, the cutout will not line up and water and debris will not clear properly.

Both. The grid sits 1 in. above the sink floor on feet, so pots and cast iron pans never touch the bowl surface, which is what prevents the scratching and dulling that shows up fast in a rental kitchen or a break room. It also has bumpers on the contact points so the grid itself does not mar the finish, and it lets water drain under stacked cookware instead of pooling.

No. The 7435000 is the grid only, supplied with its feet and bumpers. If you need a strainer or drain assembly for the bowl, order that separately.

It is corrosion-resistant stainless steel throughout, which is why it holds up in a sink that stays wet. The feet and bumpers are what wear first on any grid, so check those on turnover inspections rather than the frame itself.

Stainless steel is the only finish offered, part number 7435000.075. There is nothing to specify beyond the part number, so ordering for multiple units in a building is straightforward.