Metallics THDWH50600 Anchor 1/2 x 6 Titen HD Screw Anchor (15 pcs)

No. A Titen HD is a one piece screw anchor: you drill the hole, then drive the anchor directly into the concrete so its threads cut their own mating thread. There is no sleeve, no cone, no wedge, and no adhesive to mix or cure, which is why crews use it where they need to load the connection right after installation. The 1/2 x 6 version comes 15 to a pack.

The anchor itself backs out with a wrench or impact, which is what makes it handy for temporary bracing, formwork and fixtures that get relocated. The hole is a different matter: once a screw anchor has cut threads in the concrete, reinstalling into that same hole does not develop the original holding values. Plan on a fresh hole if the connection has to carry load again.

For panel boards, strut, transformer bases and similar equipment anchorage, the screw anchor wins on install speed and on the ability to pull the fixture back off without cutting the anchor flush. A wedge anchor is the alternative when you want a permanent, non removable fastener and don't mind that it stays in the slab forever. Both want a clean, blown out hole. This part is the 1/2 inch by 6 inch Titen HD, 15 per pack, carried as electrical fastening hardware.

THDWH50600 ships as a 15 piece pack of the 1/2 by 6 inch Titen HD, so order in multiples of 15. For a repeating layout, count your hole pattern per base plate and multiply out before you order so you're not short one anchor on the last fixture.