Metallics WAKJ141 Anchors 1/4 Red Plas Wall Ancr Kit, 10 (Jar 200)

No. Red plastic ribbed anchors in the 1/4 size are a light-duty fastener, fine for mounting low voltage plates, small brackets, conduit straps and signage. For anything carrying real weight in hollow drywall, use a toggle bolt or a self-drilling metal anchor instead, and for solid masonry use a sleeve or wedge anchor.

Drill to match the anchor body. These are the 1/4 red plastic anchors, so a 1/4 inch bit is the drill size, using a masonry bit in block, brick or plaster and a standard twist bit in drywall or wood. Drill slightly deeper than the anchor length so the anchor seats flush before the screw goes in.

The WAKJ141 is a red plastic wall anchor kit from Metallics, supplied in a jar of 200 pieces. The anchors are the 1/4 size, which is the common red plastic ribbed anchor used for light-duty fastening into drywall, plaster, block and masonry. It's a bulk jar, so it suits an electrician's van stock or a maintenance shop rather than a one-off repair.

It's sold as a wall anchor kit in a 200 count jar. The catalogue description covers the red plastic 1/4 anchors themselves, so plan on sourcing the matching screws separately unless the jar label states otherwise. For plastic ribbed anchors of this size, a #10 or #12 sheet metal screw is the usual mate.

Metallics lists the WAKJ141 as a single model, supplied as the 200 piece jar of 1/4 red plastic anchors. There's no smaller count under this part number, so if you want a mixed assortment or a small blister pack you'd be looking at a different Metallics anchor part.