B-Line 41514 10 GL Eaton series Grip Strut four diamond plank, 120" Grating length, 9.5" Grating width, Steel, 1.5" Channel size, Mill-galvanized, Grip Strut, 14 gauge steel

Yes. The 41514 10 GL plank is listed as OSHA compliant and is intended for safe, sturdy footing where a non-slip surface is required. The four-diamond punched pattern gives the traction, which is what makes it common on catwalks, mezzanine walkways, stair treads and equipment platforms.

The finish here is mill-galvanized steel, meaning the coil was galvanized before forming, so the cut and punched edges are raw steel. That's fine for damp interior and sheltered industrial use, and it's the standard economical choice for indoor catwalks. For constant weather exposure, standing water, or a corrosive wash-down area, specify a hot-dip galvanized-after-fabrication or stainless plank instead.

It's formed from 14 gauge steel with a 1.5 inch channel depth. Gauge and channel depth together drive the allowable clear span between supports, so size your support spacing from Eaton's load tables for a 1.5 inch, 14 gauge plank rather than assuming it will carry over a long unsupported run.

The 41514 10 GL is supplied as the plank alone. Saddle clips, hold-down clips or welding to the supporting steel are separate items, so add fasteners to the order when you're specifying a walkway or platform build.

Order it as Eaton B-Line 41514 10 GL. That designation covers the four-diamond Grip Strut plank, 120 inch length, 9.5 inch width, 1.5 inch channel, 14 gauge mill-galvanized steel.

Yes, 14 gauge steel plank cuts with a bandsaw or abrasive chop saw, and crews routinely trim the 120 inch length to suit a platform. Because the plank is mill-galvanized, the cut ends are bare steel, so brush on a cold galvanizing compound after cutting if the area sees any moisture.