B-Line 52514 10 GL Eaton series Grip Strut five diamond plank, 120" Grating length, 11.75" Grating width, Steel, 2.5" Channel size, Mill-galvanized, Grip Strut, 14 gauge

Each Eaton B-Line 52514 10 GL plank is 120 inches long by 11.75 inches wide, with a 2.5 inch channel depth. So one piece covers a 10 foot run just under a foot wide. For wider platforms or catwalks, planks are laid side by side to build up the walking surface you need.

The 52514 10 GL five diamond plank is listed as OSHA compliant and is made for safe, sturdy footing where a non-slip surface is required. The pierced diamond openings shed liquid, ice and debris and give traction from any direction of travel, which is why it gets specified for catwalks, mezzanine walkways, stair treads and equipment platforms.

The 52514 10 GL is steel with a mill-galvanized finish, which is a zinc coating applied to the sheet before forming. That suits covered outdoor and general industrial service. Note the cut ends and pierced edges are raw steel after fabrication, so in constant wet, coastal or chemical wash-down conditions a hot-dip galvanized or stainless plank is the better call.

At 4.7 lb, the 52514 10 GL plank is light enough for a single installer to carry and set a 10 foot length overhead on a rack or mezzanine. That matters when you are working off a lift and there is no second set of hands.

The 2.5 inch figure is the depth of the formed side channels that run the length of the plank, and it is also the overall product height. Those turned-down channels are the structural member: the deeper the channel, the further the plank spans between supports. A 2.5 inch channel is the deeper walkway plank rather than a shallow stair tread profile, so it is what you use over longer support spacing. Set your load span from the support spacing your engineer calls out for the loading.

The 52514 10 GL is formed from 14 gauge steel, the standard walkway weight for this plank family, paired with a 2.5 inch channel depth. It is built for foot traffic, maintenance access and personnel platforms rather than for wheeled or vehicle loads. If your deck sees carts, pallet jacks or point loads, size the supports accordingly and confirm the loading against your span.

The 52514 10 GL is the plank only, supplied as a single 120 inch by 11.75 inch piece. Saddle clips, hold-down hardware and any support steel are ordered separately, so add them to your take-off before the crew is on site.

Order it as Eaton B-Line part 52514 10 GL. That number covers the five diamond plank in steel, mill-galvanized, 14 gauge, 120 inch length, 11.75 inch width, 2.5 inch channel.

Yes. The 120 inch plank is 14 gauge steel and is routinely cut down on site to fit a platform opening. Cutting exposes bare steel at the ends, so touch them up with a cold galvanizing compound to keep the mill-galvanized protection continuous.