B-Line BCTS2-24 SS6 Eaton series strut pipe clamps and accessories, Support runs of conduit/pipe on same elevation, 24" 400 lbs, 36" 300 lbs load cap, Steel, Safety factor of 3,BCTS2 series,Stainless steel type 316, 2" max conduit size, 8 conduit hol

The BCTS2-24 SS6 has 8 conduit holes and takes conduit or pipe up to 2 inches. It is built to carry multiple runs at the same elevation off a single support, so you strap the whole bank on one channel instead of hanging each run separately.

Yes. The SS6 suffix is Type 316 stainless steel, which is the grade specified for coastal, chemical, wastewater, and food processing environments where chloride exposure would attack plain steel or a plated finish. For dry indoor work a plated or pre-galvanized version is the usual choice.

Yes, the BCTS2 series carries a UL Listing, which is what most AHJs want to see on a conduit support assembly in commercial and institutional work.

Individual straps make sense for one or two runs on a wall. Once you have a bank of parallel runs at the same elevation, a trapeze like the BCTS2-24 is faster and keeps spacing consistent: eight positions on one piece, one set of drops, one rated capacity to check (400 lbs at 24 inches) instead of counting straps. Anything over 2 inch conduit needs a different support.

Order MPN BCTS2-24 SS6 from Eaton B-Line. The BCTS2 is the series, 24 is the length in inches, and SS6 is the Type 316 stainless material code.

It will, as long as nothing in the bank exceeds 2 inch conduit and the total weight stays inside the rating for your span. The eight positions let you mix sizes across one support, but the capacity is for the assembly as a whole, not per hole.