B-Line BCTS2-96 SS6 Eaton series strut pipe clamps and accessories, Support runs of conduit/pipe on same elevation, 24" 400 lbs, 36" 300 lbs load cap, Steel, Safety factor of 3,BCTS2 series,Stainless steel type 316, 2" max conduit size, 32 conduit ho

The BCTS2-96 SS6 channel has 32 conduit hole positions and takes conduit or pipe up to 2 inches maximum. It is built to carry multiple runs at the same elevation on one support rather than hanging each line separately.

Yes. The SS6 suffix is type 316 stainless steel, which is the grade specified for chloride exposure, coastal air, wastewater plants and food processing washdown areas. If the run is indoors and dry, a plain steel or galvanized version of the BCTS2 is the usual choice instead.

It runs 98 inches overall, 3.625 inches wide and 1.313 inches high, and weighs 6.55 lbs. That length spans typical trapeze hanger rod pairs with room to trim, and one person can handle it on a lift.

The BCTS2 series conduit trapeze support is UL Listed, which is what an inspector on a commercial or institutional job will look for when conduit racks are part of the electrical rough-in.

The BCTS2 is a single pre-punched channel with 32 conduit positions, so runs at one elevation drop into the holes instead of each getting its own clamp on plain strut. Fewer pieces to buy and set, and consistent spacing. Where conduit sizes exceed 2 inches or you need runs stacked at different elevations, go back to standard strut and individual pipe clamps.

Yes. What you get is the 98 inch BCTS2-96 SS6 channel itself. The threaded rod, rod couplings, anchors and nuts that hang it from the structure are ordered separately, and in a 316 stainless application the hanging hardware should be matched to the same material so you do not create a galvanic or corrosion weak point.