B-Line Eaton series data and low support fasteners, Clips to beam, Cable to beam fastener, Beam mount, 9/16" Min flange thickness, 3/4" Max flange th

Rated load is 30 lb per hook, with a single 2 inch J-hook on the assembly. That 2 inch saddle is the usual size for a bundle of Cat6 runs; the 30 lb figure is the limit for everything resting in the hook, so on heavy trunk runs you space hooks closer together rather than overload one.

No drilling, no welding, no anchors. The BCH32-E-2-4 is a beam-mount clip that clamps to the flange, so the hook goes up with hand tools and the structural steel stays untouched. That's what makes it the go-to for tenant fit-outs and retrofit low voltage work where you can't modify the building steel.

Yes, the B-Line BCH32-E-2-4 is UL/CUL listed. That matters on commercial jobs where the inspector wants independent cable support rather than runs laid on ceiling grid or tied to sprinkler pipe.

The BCH32-E-2-4 is steel with a pre-galvanized finish, which is meant for dry interior environments, plenum spaces, and above ceilings. Pre-galv gives light corrosion resistance only. For wet, washdown, coastal, or exterior exposure you want a hot-dip galvanized or stainless version of the hook instead.

Overall the assembly measures 4.391 in height, 2.934 in length/depth, and 1.62 in width, so plan for roughly four and a half inches of drop from the flange once it's clamped. In tight ceiling plenums that dimension decides whether the cable bundle clears the grid and the ductwork. Each one weighs .24 lb, so a carton of them is easy to carry up the lift.