B-Line Eaton series double sided 24 inch shelf width distribution , 96" height, 37.62" length, 24" width, 6 vertical with 10 shelves, ASTM A36 structu

The configuration is 6 verticals with 10 shelves. The verticals are the upright termination fields and the shelves are the horizontal supports between them, so you are getting a complete multi-bay assembly rather than a single bay you have to gang up later. Count your required block positions against those 6 verticals before ordering, because adding capacity later means a second frame.

This one is built to support terminal blocks for central cross connects. Double sided means terminations mount on both faces of the frame, so a single 24 inch wide upright run carries twice the block density of a wall-mounted or single-sided arrangement. It is the standard approach for a main or intermediate cross-connect field where copper pairs from the outside plant are jumpered to house cable.

Because it is double sided, both faces are working surfaces, so you need front and rear access, not just front. Lay out clear aisle on both 37.62 inch faces for terminating and jumpering, and leave room at the ends for cable runway drops. A frame planned as if it were wall-mounted single-sided will strand half its capacity.

ASTM A36 structural steel with a Telco gray powder coat. A36 is the common structural carbon steel grade, so the frame is welded and bolted structural stock rather than light formed sheet, and the powder coat is the standard telco gray that matches typical central office and MDF room equipment.

Certifications are shown as Not Applicable for this frame. It is passive structural steelwork supporting terminal blocks, so there is no electrical listing attached to it. Bonding and grounding of the frame itself is handled by your installation per the job's grounding spec.