B-Line Eaton series double sided 30 inch shelf width distribution , 108" height, 43.62" length, 30" width, 10 vertical with 12 shelves, ASTM A36 struc

This is a universal distribution frame, double sided, built to support terminal blocks for central cross connects. Double sided means blocks mount on both faces of the 30 inch wide shelves, so you get roughly twice the termination capacity in the same 43.62 by 30 inch footprint, but you must be able to work both sides, which means aisle access front and rear. If the frame has to sit against a wall, a single sided frame is the right choice because the back face becomes unusable.

Ten verticals and twelve shelves, with a 30 inch shelf width. That is the configuration as supplied, so you are sizing your terminal block layout against twelve shelf positions across ten verticals rather than adding shelves later.

Construction is ASTM A36 structural steel with a Telco gray powder coat, which is the standard finish on central office and telecom room ironwork, so it lines up visually with existing Telco gray ladder rack and relay racks. Painted powder coat means it is intended for dry indoor telecom and equipment rooms, not wet or corrosive locations.

Order Eaton B-Line part number SB60410810TG. That number covers the double sided universal distribution frame at 108 inches high, 43.62 inches deep, 30 inches wide, with ten verticals and twelve shelves, in Telco gray.

No certifications are carried on this frame. It is structural ironwork for supporting terminal blocks, not an electrical device, so any listing requirement in your specification will apply to the blocks, protectors, and cabling you mount on it rather than to the frame itself.