B-Line Eaton series double sided 30 inch shelf width distribution , 108" height, 43.62" length, 30" width, 5 vertical with 12 shelves, ASTM A36 struct

This one is built to support terminal blocks for central cross connects. Double sided means blocks mount on both faces of the frame, so you can land incoming cable on one side and distribution on the other and run jumpers between them. It is a cross-connect field, not an equipment rack, so it is not intended for rack-mount gear.

It is configured with 5 verticals and 12 shelves. The 5 verticals set the horizontal mounting bays across the 30 inch width, and the 12 shelves give you the tiers for terminal block mounting up the 108 inch height. If your block count or jumper routing needs a different bay layout, you need a different configuration in the series rather than field-modifying this one.

It weighs 400.64 lb bare, before any terminal blocks, cable or shelving load. That is a two-person-plus-equipment lift, and on a raised access floor you generally want the frame anchored through to the structural slab rather than sitting on floor panels. The footprint carrying that load is only 43.62 by 30 inches.

The frame is ASTM A36 structural steel with a Telco gray powder coat. That is the standard finish for central office and telecom room ironwork, so it will visually match existing Telco gray racks, ladder rack and auxiliary framing already in the room.

The SB60410805TG is a steel structural frame with no certification or listing attached to it. Buyers standardizing a facility should treat it as structural ironwork and apply their room's grounding and bonding practice to it as they would any other steel frame.