B-Line Eaton series ground mounted panel enclosure, 60" height, 20" length, 60" width, 4X, Hinged cover, ES4XS enclosure, Ground mount, Large double

It carries a NEMA 4X rating and is built from 304 stainless steel with a closed cell neoprene gasket, so it is intended for wet, washdown, and corrosion-prone locations rather than dry indoor duty only. The 4X designation is what separates it from a plain 4 enclosure: same water and dust protection, plus corrosion resistance from the stainless shell.

60 inches high, 60 inches wide, and 20 inches deep. That is a large double door cabinet, so allow full door swing clearance in front plus room either side of the 60 inch width when you lay out the pad.

503.3 lb empty. That is a rigging job, not a two-man lift. Plan on a forklift, hoist, or crane to get it onto the pad, and remember that is before any panel, breakers, or wireway go in.

No. It ships with no mounting provisions inside, so there is no sub-panel, no rails, and no weld studs. You order the back panel and any internal mounting hardware separately and size it to the 60 x 60 interior opening.

Yes. The doors use a stainless handle with 3-point latching, and there is a key lock padlock provision, so you can either key it or hang a padlock for lockout or site security. The 3-point latch pulls the door tight at top, middle, and bottom, which is what keeps the gasket seal even across a 60 inch door.

It is listed to UL 508A, which is the standard for industrial control panels, so a panel shop can build a control assembly in it and label the finished panel accordingly. Note it arrives empty with no internal mounting provisions.

It is a ground mount design, meant to sit on a pad or foundation rather than hang on a wall or strut. The enclosure itself has no factory mounting provisions, so anchoring is done through whatever base or pad detail your drawing calls for.

The body is 12 gauge 304 stainless, which is a heavy commercial wall thickness compared with the 14 or 16 gauge used on lighter enclosures. Combined with the 3-point latch it holds shape in traffic areas and around equipment yards.

Hinged, in a large double door arrangement. Both leaves swing rather than lifting away, so a single tech can open it in the field without setting a heavy cover on the ground, and you need swing clearance in front of the full 60 inch width.

Go stainless 4X where washdown chemicals, salt air, fertilizer, or coastal humidity are in play, since the 304 stainless shell resists corrosion that would eventually undercut paint on a carbon steel box. Painted 4 steel is the cheaper choice for a sheltered or inland pad with no chemical exposure. The 4X here also brings a 12 gauge body and neoprene gasket for the seal.

A #4 brushed stainless finish, which reads as a grey satin grain rather than a painted or mirror surface. It matches the usual #4 brushed stainless used on food, pharma, and water treatment equipment.

Country of origin is the US. The orderable model number is ES-606020-4XS in the Eaton B-Line ES4XS enclosure line.