B-Line Eaton series open racks, 60.375" height, 21.625" length, 3.625" width, Aluminum, RCM rack mounted vertical cable manager double sided, Cable s

The RCM double sided vertical manager, model SB86083D066FB, is 3.625 in wide and 21.625 in deep, so it needs 3-5/8 inches of clear floor and side space alongside the rack and a footprint that matches a roughly 21-5/8 inch deep channel. Height is 60.375 in, so it covers the upper portion of a taller open frame rack rather than the full 84 inch height of a standard 45U frame.

This one is built for lower density work. The gate is low density plastic and the stated application is routing lower density cabling between racks. If you are filling a 48-port patch field per RU with full Cat6A bundles, you want a wider, higher capacity manager with a metal or high density gate instead.

Yes. The RCM channel is set up for direct PDU mounting, so a vertical PDU attaches into the manager itself rather than needing separate rack rails or brackets. That keeps the power strip out of the usable rack U space.

Yes, it is a double sided RCM manager, so cable is routed and retained on both the front and rear faces of the channel. That matters when you are separating patch cabling at the front from switch uplinks and power at the rear in the same vertical run.

Push in fasteners and a cable strap mount are included. The cable strap mount gives you a defined anchor point for hook and loop straps or ties along the channel, so you are not improvising tie-off points. Note that this is a rack mounted manager, so it attaches to an existing open frame rack, which is bought separately.

UL is the certification carried on the RCM manager, model SB86083D066FB. That is usually the item spec inspectors and institutional procurement ask for on rack-mounted pathway and cable management components.

It is intended for routing cabling between racks, so in a lineup you typically place one channel in each gap between adjacent frames plus one at each end of the row. Being double sided, a single unit serves the front and rear pathways for the racks on either side of it.

The finish is flat black powder coat over aluminum with black plastic gate components, which is the standard black used across Eaton B-Line series open frame racks. If your existing racks are black, the manager blends; if you standardized on grey or white frames, the contrast will show.