B-Line Eaton series open racks, 72" height, 67.375" length, 2" width, Aluminum, RCM rack mounted vertical cable manager, Rack mounting, Double sided

The Eaton B-Line RCM vertical cable manager, part SB86286D072FB, is 2 inches wide, so it takes up only a couple of inches of aisle or ganging space between adjacent open frame racks. It mounts to the rack itself rather than to the floor or wall, so you need available vertical rail space on the rack side, not extra floor footprint. At 2 inches it is a low density manager, not a wide-body manager for heavy trunk bundles.

Yes. The RCM manager is a double sided unit with low density plastic gates, so you get a front channel and a rear channel off one 2 inch body. Data center and MDF techs commonly use that to keep patch cords on one side and permanent link or fiber on the other without buying two managers.

This one is built for routing lower density cabling, meaning moderate patch cord counts on a switch or patch panel rack. If you are landing hundreds of copper drops on a 48-port-per-RU stack, a 2 inch channel fills fast and a wider vertical manager is the better call. For a network closet rack with a few panels and a couple of switches, the 2 inch double sided body is the right size.

UL is the certification carried on the B-Line RCM vertical cable manager. That is what a facilities or institutional spec typically asks for on rack accessories, so it can go in alongside UL-listed racking without an exception on the submittal.

No. The unit ships with its vertical cabling sections and the low density plastic gates included, so the body, the routing sections and the gates come together. You supply only the rack mounting hardware appropriate to your rack rails.

Flat black powder coat over aluminum, with black plastic gate components. That matches the standard flat black finish used across B-Line series open frame racks, so adding one to an existing black rack lineup looks consistent.

It weighs 2.625 lb, so a single installer can hold a 72 inch length in place and start the top fasteners without a helper or a lift. The aluminum body is what keeps the weight down at that height.