B-Line Eaton series open racks, 96" height, 12.75" length, 6" width, Rack mounted vertical cabling section dual hinging removable, Telco gray powder

It's a 96 inch tall vertical cabling section, 6 inches wide and 12.75 inches deep, finished in Telco gray powder coat. That height matches a standard full-height open frame rack, and the 6 inch channel width is the narrower of the common manager sizes, so plan your bundle fill accordingly if you're terminating high-count copper.

Yes. The SB57166D096TG ships with 1/2"-13 mounting hardware for fastening the section to the rack uprights, so you don't need to source separate bolts for the rack-to-manager connection. Floor anchors for the rack itself are a separate item.

It's a rack mounted vertical cabling section, not a freestanding rack. It bolts to the side of an open frame rack to organize cable vertically, so you need the rack itself plus any bays, plus your horizontal managers, to complete the install.

The gate on the front of the channel swings from either side and lifts off entirely. For an installer that means you can work a large bundle into the channel with the door out of the way, then reinstall it, rather than threading cable through a fixed covered raceway. Eaton describes it as a removable gate for quick cable install.

It's Telco gray powder coat, the standard gray used across the Eaton B-Line open frame rack line, so it lines up with racks already specified in that finish. If your room is built out in black, this section will stand out.

Depends on port count. The SB57166D096TG gives a 6 inch wide by 12.75 inch deep channel, which suits patching between adjacent racks and moderate copper counts. If you're landing several high-density 48-port panels per rack, or running fiber trunks plus copper in the same channel, step up to a wider section instead of overfilling this one and crushing bend radius.