B-Line Eaton series open racks, Aluminum, 4 mounting units, Flat black powder coat, Wall mounted patch panel bracket 19" or 23" panel mount, hinged

Four mounting units (4U) of usable panel space. That takes a pair of 24-port 1U patch panels plus a 1U wire manager, or a single 4U panel, with nothing left over. If you need more than four rack units, this is the wrong bracket size.

It measures 23 in wide, 7 in high, and 6 in deep, and weighs 9 lb. The 6 inch depth is the number that matters in a tight closet, it sets how far the bracket and panel stand off the wall before you add cable bend radius behind the terminations.

The hinge lets the loaded panel swing away from the wall so you can reach the rear terminations, the punchdowns or the back of the jacks, without pulling the panel off its rails. On a fixed bracket you are working blind behind a panel that is bolted flat to the wall. If you expect to add or re-terminate ports after the initial install, the hinged version saves the labor.

What you are ordering is the bracket itself, model SB750230604FB, in aluminum with the flat black powder coat finish. Plan on supplying the patch panels, panel mounting screws, and the wall fasteners suited to your substrate, anchors for masonry or block, lag screws into studs or plywood backboard.

Aluminum, finished in flat black powder coat. Aluminum will not rust the way a bare or painted steel bracket does if humidity gets into a basement or mechanical room, and at 9 lb the bracket itself puts very little load on the wall structure before you add panels and cable.

The finish is flat black powder coat, the same non-gloss black used across most open frame racks and panel hardware, so it reads consistent alongside existing black racks and panels. There is one configuration on this model, SB750230604FB, so every bracket you order for a rollout is identical.