B-Line Eaton series open racks, Aluminum, Flat black powder coat finish, Rack mounted horizontal transition trays for patchcords and jumpers

The SB813TP6FB is a rack mounted horizontal transition tray, used to route patchcords and jumpers as they transition from vertical cable management into the equipment or patch panels. It is an aluminum tray with a flat black powder coat finish, intended for Eaton B-Line series open frame racks.

It is aluminum, finished in flat black powder coat, so it matches black powder coated open racks and vertical managers visually. Aluminum keeps the part light at 4 lb, which matters when you are hanging several trays on a two-post rack that is only anchored at the floor.

They do different jobs. A horizontal transition tray like the SB813TP6FB is an open shelf that carries patchcords and jumpers across the rack face and turns them into the vertical managers, keeping bend radius under control where cords leave the panel. A horizontal cable manager with rings or a finger duct organizes and confines cords at a specific panel. On dense fiber and copper cross-connect frames, installers commonly use both: the tray for the transition run, the manager for the individual port.

Order by model SB813TP6FB, the flat black powder coat aluminum version of the Eaton B-Line rack mounted horizontal transition tray. That is the only configuration on the part number, so there is no finish or size option to specify. Mounting hardware for your rack rails is not itemized in the spec data, so plan your rack screws around the thread on your existing frame.

Certifications are marked Not Applicable for this transition tray. It is a passive aluminum cable management accessory, not a powered or grounded electrical device, so there is no listing to reference on a submittal for it.