B-Line Eaton series open racks, Steel, #12-24 Bolts and nuts included, Telco gray powder coat finish, Bumper rail extension - network bay

It's a bumper rail extension for a network bay on Eaton B-Line series open frame racks. The steel extension bolts onto the rack to extend the bumper rail surface, and it ships with four #12-24 bolts and nuts so no separate fastener pack is needed. Finish is Telco gray powder coat, which matches the standard Telco gray open frame racks in a typical telecom or IDF room.

The extension measures 19.88 inches across, which is the standard footprint for a 19 inch EIA open frame rack where the rail spans slightly wider than the 19 inch mounting opening. Depth is 3 inches and height is 1 inch. If your open frame rack is a wider or metric bay rather than a 19 inch bay, this piece is not the right width.

No. Four #12-24 bolts and nuts come with the SB592419X3TG extension. #12-24 is the thread B-Line uses on its open frame rack rails, so the hardware in the box matches the rack's tapped or punched rail holes. If you're adding several extensions across a row of bays, each part carries its own set of four.

Telco gray powder coat is the standard B-Line series open frame rack color, so the extension is meant to blend with Telco gray racks already in the room. If your bays are black powder coat, the gray piece will be visibly different, so specify a black finish version instead of this one.

Order Eaton B-Line SB592419X3TG. That is the single model for the 19.88 inch wide, 3 inch deep, 1 inch tall Telco gray steel bumper rail extension for a network bay.

It weighs 6.2 pounds, so it's a one-person install on a ladder or from the floor depending on mounting height. The four included bolts and nuts are the only fasteners required.

It's steel with a Telco gray powder coat finish, meaning the surface is painted and not a bare conductive path. Treat it as a mechanical accessory, not part of your rack bonding scheme, and run your grounding through the rack's designated bonding points.