B-Line Eaton series runway wall angle support kit, Used to secure cable runway to a wall, Includes angle bracket, J bolt and 5?16-18 hardware, 18" run

The kit ships with the angle bracket, a J bolt, and 5/16-18 hardware to join the bracket to the cable runway. What is not in the box is the wall anchor. The fastener that goes into concrete, block, or a stud has to be selected for your wall type and supplied separately.

It is built for an 18 inch run, and the overall part measures 19.13 inches across with a 1.63 inch height and 1.63 inch depth on the angle leg. That run length sets how far the runway sits out from the wall, so match it to the runway width you are supporting in your data room or equipment room.

The bracket is 6 gauge ASTM A569 steel with a yellow zinc plating, which is an indoor corrosion coating. It suits conditioned and typical unconditioned interior spaces such as telecom closets, basements, and back-of-house rooms. For exterior or washdown areas, specify a hot dip galvanized or stainless support instead.

Yes, the runway wall angle support kit is UL Listed. That matters on institutional and government jobs where the spec calls for listed cable pathway support components.

A wall angle support carries the runway off the wall surface, which is the right call when the runway runs along a wall, the ceiling structure will not take load, or you want the pathway low enough to work from a stepladder. Ceiling-hung threaded rod is the choice for runway crossing open floor space away from any wall. This B-Line kit is the wall-mounted type and secures the runway to the wall with the supplied J bolt and 5/16-18 hardware.

The kit uses 5/16-18 hardware at the runway connection. If you are stocking spares for an MRO crib or standardizing a building's data rooms, that is the thread to buy, and the kit part number is SB211318YZ.