B-Line Eaton series strut fittings and accessories, 6" Height, 20.5" Length, 1.62" Width, 4.90lbs, Steel, Bracket, Uniform load capacity 600 lb, Stain

The B292SS6 strut bracket is listed with a steel material and a Type 316 stainless steel finish. Type 316 is the marine/chemical grade, so it is the version people specify for coastal, wastewater, food processing and washdown areas rather than a painted or plain-plated fitting used indoors.

It carries a uniform load capacity of 600 lb. That is a uniformly distributed rating, not a point load at the end of the arm, so a concentrated load hung at the far end of the 20.5 inch length should be derated by your engineer of record.

The B292SS6 is punched with four 9/16 inch diameter holes plus two more at 9/16 inch diameter. That 9/16 inch hole is the standard strut fitting pattern for 1/2 inch hardware, so it bolts up with 1/2 inch strut nuts and bolts. Order the fasteners separately, and match them in Type 316 stainless if you want the corrosion resistance of the bracket to carry through the whole connection.

Yes. The Type 316 stainless finish is the grade chosen for salt air, chlorides and chemical exposure, which is why it shows up on coastal rooftops, pool rooms, treatment plants and process piping supports. In a dry indoor electrical room a plain electro-galvanized strut bracket would do the same mechanical job.

It is a strut bracket, part of the Eaton B-Line strut fittings and accessories line. Brackets like this bolt into a channel run to form a support arm or an angled connection for conduit, cable tray, pipe, equipment stands and seismic bracing. The bracket is the connecting piece only, the strut channel and the fasteners are separate items.

Order it as B292SS6. The SS6 in the designation corresponds to the Type 316 stainless version, so confirm the suffix when substituting, since the same bracket geometry is sold in other finishes under a different suffix.