Baldwin Reserve Arch Single Cylinder Keyed Entry Leverset with Rustic Rose

It drops into the standard 2-1/8 inch cross bore with a 1 inch edge bore, so a door already prepped for a cylindrical lockset takes it without new boring. Backset works at either 2-3/8 or 2-3/4 inches, the two standard bored-lock backsets, so measure from the door edge to the center of the hole and order to match.

Yes. The Reserve entry lever uses a C-Keyway pin and tumbler cylinder, and you can order it keyed alike so several openings run on one key, or keyed different if each door needs its own. If you already have a Baldwin C-keyway key code in the building, enter that code with the order and the set arrives keyed to it.

It is a residential lockset, so for a leased corridor, a stairwell, or anywhere the door falls under commercial hardware requirements you want a graded commercial lever instead. The Hager 2525 is a Grade 2 commercial cylindrical entry lock for 1-3/8 to 2 inch doors, and the Dexter C1000 entry/office lever is Grade 1 for 1-3/8 to 1-3/4 inch doors. Keep the Baldwin Reserve for house entries, unit front doors on the interior side of a residence, and side doors.

The Baldwin Reserve Arch keyed entry leverset uses a C-Keyway pin and tumbler cylinder, and it can be ordered keyed alike or keyed different. If the rest of the openings need to run on the same key, the Cal-Royal AG00 is an entrance lever with a 6-pin Schlage C keyway supplied keyed different on a 2-3/8 inch backset, and the Cal-Royal AG03 classroom lever uses the same 6-pin Schlage C keyway on a 2-3/4 inch backset. The Baldwin covers both backsets, 2-3/8 or 2-3/4.

The Baldwin Reserve Arch keyed entry leverset is a residential cylindrical lock with an entry function and a C-Keyway cylinder. For a commercial opening where the specification calls out an ANSI grade, the Hager 2525 is a Grade 2 commercial cylindrical entry lock with a lever handle covering doors 1-3/8 inch to 2 inch thick, and the Falcon B511CP6D is a Grade 2 medium duty cylindrical lever with entry/office function. Both carry a stated grade; the Baldwin is built for residential entrances, side doors, and similar openings.

The Baldwin Reserve Arch entry leverset is keyed with a single cylinder, so every user needs a key. For code entry instead, the Lockey 2835 is a mechanical pushbutton keyless lever lock with passage function and ADA compliance fitting doors 1 3/16 inch to 2 inch, the Lockey 2835DC adds a double combination on the same door thickness range, and the Delaney LP250 is a Grade 2 electronic keypad leverlock. The Lockey 1150 is a heavy duty mechanical keypad lever set for doors 1-1/8 inch to 2 inch.

No. The Baldwin Reserve Arch leverset is a keyed single cylinder entry lock. The Bravura Miramar with round trim is a Grade 2 passage leverset in US4 satin brass, which latches but does not lock, and the Callan Bentley is a Grade 2 dummy lever, which is trim only with no latch at all. A dummy or passage lever will not secure an entrance door. For a keyed entrance in a similar residential lever style, the Master Lock BC Series return style lever is a Grade 3 keyed entry lockset and the Callan Artino is a Grade 3 entrance leverset.

The Baldwin Reserve Arch is an entry function, so the lever unlocks from inside and can be left unlocked. For an opening that must stay locked from the outside at all times with key access only, the Cal-Royal AG05 is a Grade 2 storeroom lever lockset with a deadlocking latchbolt for doors 1-3/8 inch to 1-3/4 inch, and the Hager 2580 is a Grade 2 storeroom cylindrical lock with a Withnell lever covering 1-3/8 inch to 2 inch.

The Baldwin Reserve Arch is a residential keyed entry leverset. Where the opening is fire rated, the Falcon K101 is a Grade 1 heavy duty passage cylindrical lock with non-handed levers, fire rated, covering doors 1-3/8 inch to 2-1/4 inch, and the Corbin Russwin CL3110 is a Grade 1 vandal resistant passage lever lock, fire rated, for doors 1-3/4 inch to 2 inch. Both are passage function, so pair them with separate keyed hardware where the door also needs to lock.

Single cylinder means one keyed cylinder, on the outside lever only. The inside lever is always free to turn for egress, and locking is done from the inside without a key. It is an entry function set for a front door, side door, or any opening that needs to be locked and keyed rather than just latched.

Yes. The Reserve entry lever can be ordered split, so the outside face can carry one finish or rose and the inside another. That matters when an entry door faces a bronze exterior package but opens into a room finished differently. Enter the split rose and split finish you want with the order; lever handing can also be split if you want the levers turning to opposite sides.

The Baldwin Reserve is a mechanical keyed entry lever on a C-Keyway cylinder, which means rekeying between tenants. If you would rather change a code than a cylinder, the Lockey 2835 mechanical pushbutton keyless lever fits 1-3/16 to 2 inch doors, and the Lockey 1150 heavy duty keypad lever set covers 1-1/8 to 2 inch. The tradeoff is appearance: the Reserve rustic rose is decorative hardware, the keypads are not.

The Baldwin Reserve Arch leverset is keyed with a single cylinder entry function, so it locks. For a hall, closet, or other interior door that only needs a latch, non-keyed lever options include the Bravura Tampa with square trim, a Grade 2 passage leverset, the Bravura Atlanta with round trim, also Grade 2 passage, and the Callan Asheville, a Grade 3 passage leverset in a satin nickel finish. Choose the rose shape that matches the rest of the doors - the Reserve Arch is offered with a Rustic Arch rose and a Rustic Square rose.

The Baldwin Reserve Arch is a residential entry leverset with a single cylinder. For a classroom, the Dexter C1000 Series classroom lever is Grade 1, clutching and keyed for doors 1-3/8 inch to 1-3/4 inch, and the C1000 classroom security version is Grade 1 on the same door range. For utility and institutional openings, the Dexter C1000 asylum function is Grade 1 covering 1-3/8 inch to 2 inch. Those carry a Grade 1 rating; the Reserve Arch is built for residential entrances.

No. The Baldwin Reserve Arch is a standalone cylindrical entry leverset with a mechanical single cylinder. For exit device trim, the Corbin Russwin 585F715 is a Grade 1 lock lever for the ED8000 pushpad exit device in the CL3300 cylindrical lock series, fitting doors 1-3/4 inch to 2 inch, and the Imperial USA ED-EL500HD is a heavy duty escutcheon lever trim with entry function. For access control, the Corbin Russwin CL33903 is a Grade 1 fail safe electrified cylindrical lever at 12VAC/DC for doors 1-3/4 inch to 2 inch.

Two rustic rose shapes, Rustic Arch (RAR) and Rustic Square (RSR), and two finishes, 481 Dark Bronze and 492 White Bronze. Both roses are available in both finishes, so pick the rose to suit the door style and the finish to match the rest of the hardware on the opening.

The Reserve keyed entry lever is one function in the Reserve Series, which is built so knob and lever styles carry across a house on the same 2-1/8 inch bored prep. Use the keyed entry set on doors that lock from the outside, and match the non-keyed functions from the same Reserve collection on interior and closet doors so the rose and finish read the same down the hall.

The Baldwin Reserve Arch is a lever handle with an entry function. If the opening calls for a knob instead, the Arrow HK11-BB is a turn-pushbutton entrance cylindrical lock with a ball knob and a conventional cylinder for doors 1-3/8 inch to 1-3/4 inch. Note that the Reserve Arch keyed cylinder is C-Keyway, so a knob on a different cylinder will key separately.

The Baldwin Reserve Arch keyed entry leverset is a working cylindrical lock. On closet fronts, inactive leaves of a pair, and similar doors that need only the handle, dummy trim is the match: the Emtek Arts and Crafts lever is offered as a dummy pair, the Emtek Hammered lever as a dummy pair, and the Emtek Cortina brass lever as a dummy pair. In heavy duty commercial trim, the BEST 9K Series 1DT is a Grade 1 non-keyed single dummy trim and the BEST 7KC Series 1DT is a Grade 2 medium duty single dummy.