Metallics POZI2 Bit No.2 Pozidrive Bit 2" Long

No. The Metallics POZI2 is a No.2 Pozidriv bit, and Pozidriv is a different geometry from Phillips. A Pozidriv recess has four extra radial ticks between the main cross slots, and the bit has matching ribs with a blunter tip angle so it seats deeper and cams out less. A Phillips No.2 driven into a Pozidriv screw will wobble and chew the recess, and a Pozidriv bit in a Phillips head sits high. Match the bit to the screw head, not just the size number.

Look at the screw head under light. If you see four short lines set at 45 degrees between the arms of the cross, it is Pozidriv and the Metallics POZI2 No.2 bit is the correct driver. A plain cross with no tick marks is Phillips. No.2 covers the bulk of mid-size screws in both systems, so the tick marks, not the size, are what decide it.

Two inches overall. That is the longer insert-bit length, so it reaches past a magnetic bit holder or into a slightly recessed screw where a 1-inch insert bit would bottom out on the holder. Order the POZI2 model for the No.2 Pozidriv tip.

The POZI2 is a 2-inch drive bit for driving No.2 Pozidriv screws. It is sold as a single model with no shank or hex-size options, so if your tool or bit holder takes standard insert bits you are ordering the only configuration offered.

It is an electrical-department drive bit, used for driving No.2 Pozidriv screws, the head style common on European-made fixtures, luminaires, panelboard components and imported device hardware. Electricians and maintenance techs keep one in the pouch specifically so an imported fixture screw does not get destroyed by a Phillips bit.