Metallics JG5HTB2D Bolts 1/4-20 X 1 G5 Hx Tap Blt S (Jar 100)

It's a 1/4-20 hex tap bolt, 1 inch long, with 20 threads per inch and a right hand thread. Shank diameter runs 0.2450 to 0.2500 inch, and the thread conforms to ASME B18.2.1-2012. Tap bolt means it's threaded the full length, so you can run it into a tapped hole or use it with a nut.

Yes. The JG5HTB2D is flagged Buy American compliant and ARRA compliant, with country of origin United States, so it clears domestic-content requirements on federally funded work.

The finish is zinc plating over steel, which handles indoor, damp, and sheltered exterior service. For constant weather exposure, washdown, or coastal conditions, zinc plating will eventually corrode and stainless or hot dip galvanized hardware is the better call.

These ship as a jar of 100 pieces, and 100 count is the order minimum. Metallics does offer other sizes and quantities by request if 1/4-20 x 1 inch isn't what your job needs.

A tap bolt is threaded the full length of the shank instead of having a plain grip section, so it works in tapped holes of varying depth and gives full thread engagement on thin assemblies. The JG5HTB2D is a 1/4-20 x 1 inch Grade 5 tap bolt in zinc. If your joint needs a plain shank bearing in a reamed hole, use a partially threaded hex cap screw instead.

Head height runs 0.150 to 0.163 inch and head width across flats 0.428 to 0.438 inch. The jar itself measures 3 in by 2.7 in by 76.2 mm and weighs 794 g with 100 bolts in it, which matters if you're stocking a service van drawer or a shop bin.

Material is steel to AISI 1008 through 1026, heat treated to Grade 5 properties and finished in zinc. That's a medium carbon range, which is why it reaches 120,000 psi minimum tensile rather than the lower values of an unhardened Grade 2 bolt.