Cahaba CASS1915UMSB 19 in. Micro Radius Single Bowl Undermount Rectangle 16 Ga. Stainless Steel Bar Sink

No mounting hardware is included. It is an undermount sink, so you or your fabricator supply the clips, studs, epoxy and silicone to set it to the underside of the stone. A basin rack is included in the box.

Rear drain placement. That pushes the tailpiece and trap toward the back wall of the cabinet, which keeps the usable floor of the cabinet clear for a trash pull-out or storage, and it drains water off the bowl bottom rather than puddling in the middle. Set your drain stub-out to the rear of the 24 inch base accordingly.

16 gauge is the heavier of the two common stainless sink thicknesses and it is what holds up in hospitality and multi-family common-area service. Thicker steel deadens the drumming you get from 18 and 20 gauge bowls and resists denting from glassware and ice. The whole body is stainless steel in a brushed finish, which hides scratching better than a mirror polish in a high-traffic bar.

No. There are no deck holes to work with on an undermount bowl, so the faucet and any air gap or soap dispenser drill through the countertop or backsplash behind the sink. Order the faucet separately and confirm the spout reach clears the 15 inch bowl width.

Micro radius means the corners are turned to a very tight radius instead of a full sweep, so the bowl reads almost square and matches modern slab countertops visually. Unlike a true zero radius corner, the small radius still leaves enough room to get a rag or brush into the corner, so lime and coffee grounds do not pack in. Combined with the rear drain, cleanup is straightforward in a daily-use bar.