MLRK1-HAG
Motorized Latch Retraction Kit for Hager 4500, IDC 8000, PDQ 6200, Stanley QED, LSDA 9000 and Lawrence 8000 Series Exit Device
The MLRK1-HAG is a practical and cost-effective way to convert a mechanical Hager 4500, IDC
8000, LSDA 9000 R/V, PDQ 6200, Stanley QED 1/2000 & Lawrence 8000 series device to an electrified latch pullback device while maintaining the UL listing. Our easy-to-install motor-driven kit
installs in moments. It is equipped with PTS technology allowing for an easy post-installation adjustment of the latch/latches. Last but not least, it features an updated MM5 module with improved
torque & 1 Touch PTS!
Features:
• MM5 Smart Module: On board diagnostics with audible feedback for adjustment and power issues
• “PTS”: 5 second electronic adjustment for easy post installation adjustment
• Electric dogging rated for continuous duty
- Auto re-engage if push pad is pulled from dogged position
• Low Current Draw - Field switchable to “High Torque” mode
• Up to 300’ wire run with 2-18ga wire - Long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel
• 6” robust Molex Pigtail + 6’ Power lead to easily connect to power supply lead
• Request-to-exit kit available
• 3-year “no hassle” warranty
Specifications
Voltage:
• Voltage range – 24V +/- 10%
• System protection – unit shutdown when voltage exceeds 28VDC
• Average Current Peak: 900A
• Average Current Hold: 215mA
• PTS adjustment – approx. 1/4”
Wire Run:
• 300’ with 18ga wire
Product Details:
• Weight: 2 Lbs
Device Cutdown Details:
• 36” & 48” - Minimum 8.5” of Filler Plate
