Deltana SPTS275 T-Strike for Commercial Lock, Solid Brass

No. It's a T-strike for a commercial lockset latch, not a deadbolt strike. For a deadbolt opening look at a purpose-made deadbolt strike such as the Emtek 83223 square-corner strike plate or the Kwikset 80318 full round adjustable strike.

ASA prep takes a specific 4-7/8 inch strike, which is a different plate from a 2-3/4 T-strike. For an ASA-prepped frame, the Codelocks ASA strike plate in stainless is the part built for that cutout. Use the Deltana SPTS275 where the frame is prepped for a T-strike.

The Deltana SPTS275 is a 2-3/4 inch T-strike in solid brass intended for a commercial lock, so the plate carries the T-shaped opening a latch-and-deadbolt commercial lockset needs. The Emtek 83223 is a standard deadbolt strike plate with square corners, a single-opening plate for a deadbolt bolt only. If the door has a commercial lock with both a latch and a bolt, the T-shaped plate is the one that matches the mortise; a deadbolt-only plate will not.

They are not interchangeable in function. The Kwikset 80318 is a full round adjustable strike and the Kwikset 81825 is a 6 way adjustable deadlatch, both deadbolt strike plate parts sized for residential bored locks. The Deltana SPTS275 is a 2-3/4 inch solid brass T-strike for a commercial lock. Adjustable round strikes fit a round bore in the jamb, not a T-shaped mortise.

The SPTS275 is sold as a single strike plate, each. No dust box or strike box is included. If your frame prep needs one, a separate box like the Kwikset 81231-001 metal strike dust box or the Kwikset 81640 strike box covers that.

Two: Brushed Chrome and Polished Brass. Pick the one that matches the lever or knob rose already on the door, since a strike sits in the frame directly beside the trim and a mismatched finish reads immediately.

Solid brass. Both the material and substrate are brass, so the plate is brass through its thickness rather than a plated steel blank. That matters on exterior frames and high-traffic openings where a plated finish wears at the latch strike point.

Only across two finish groups. The T-strike is offered in Brushed Chrome and Polished Brass, so a property with satin nickel or oil-rubbed bronze trim won't get an exact match from this model. Buildings running chrome or bright brass hardware can standardize on one strike for every opening prepped for a 2-3/4 T-strike.

No handing to specify. A T-strike plate is symmetrical about its long axis, so the same SPTS275 works on a left or right hand door; just order the finish you need.