B-Line Eaton series free standing enclosure accessories, 4, Used to mount panels in upper or lower sections, Steel, Full and half swing panel, Channe

It is a steel swing panel that mounts inside an Eaton B-Line free standing enclosure to carry components in either the upper or lower section of the cabinet. It is a channel mount full and half swing panel, so it pivots out of the way to give you access behind it instead of being a fixed back panel.

The panel measures 24.75 x 18.75 x 24.75 inches per the published height, width and length/depth figures, and it weighs 23.007 lb. Check those against the free space in your enclosure section before ordering, since a swing panel needs clearance to rotate as well as room to sit.

Yes. The AF6024HSWP is a NEMA rated accessory specified for NEMA 4 free standing enclosures, so it suits washdown and hose-directed-water cabinets. The rating belongs to the enclosure system; the panel itself is an internal steel mounting component and does not create the seal.

A half swing panel occupies part of the cabinet height, so you can run one in the upper section and one in the lower, or pair it with a fixed back panel behind it for two layers of component mounting. A full-height swing panel takes the whole opening and suits a single large layout. The AF6024HSWP is the full and half swing panel type, mounted on channel, and is intended for upper or lower section mounting.

Order Eaton B-Line AF6024HSWP. The AF prefix identifies the free standing enclosure accessory line and HSWP identifies it as the half swing panel.

It is a steel swing panel, so it takes drilling and tapping for DIN rail, contactors, drives and terminal blocks the same way a standard back panel does. At 23.007 lb, plan the component load and weight distribution on a panel that swings rather than sits flat against the enclosure back.