B-Line Eaton series imperial cable tray and ladder, 4" Height, 28.912" Length, 24" Width, Series 2-5 vertical inside bend, Aluminum, 60° Angle, 24" Ra

A vertical inside bend carries the tray run up or down while the fitting curves toward the inside of the change in direction, so the cables stay on the load-bearing side of the radius. Model 4A-24-60VI24 turns the run through 60 degrees on a 24 inch radius. If your elevation change curves the other way (tray bottom on the outside of the turn), you need a vertical outside bend instead, not this one.

Yes, provided your straight sections are Eaton B-Line Series 2 through 5 imperial ladder tray at 24 inch inside width and 4 inch side rail height. That is exactly what this fitting is built to: 24 inch width, 4 inch height, aluminum. Match the series as well as the dimensions, because rail profiles and splice plate holes differ between series.

The fitting bends on a 24 inch radius, which sets the minimum bend the conductors see through the turn. Check it against the minimum bending radius of your largest cable, typically given as a multiple of overall diameter by the cable manufacturer. If your cable needs more than 24 inches, step up to a larger radius bend in the same 24 inch width rather than forcing the pull.

Allow 28.912 inches of overall length for the fitting itself. Lay that out from the splice point before you cut your last straight section, because a 24 inch radius 60 degree bend eats more run than people expect and trimming a fitting is not an option.

Aluminum is the usual choice where steel would rust, and it is what this bend is made from. It is also the lighter option: the fitting weighs 8.864 lb, which matters when you are working it overhead off a lift. For heavy chemical exposure or wash-down, spec a coated or stainless tray system instead and keep the whole run in one material so you are not mixing dissimilar metals at the splices.

It is CSA certified, which is what an inspector on a Canadian project will look for on the tray fittings.

The 4A-24-60VI24 is the bend fitting only. Splice plates and their bolt-and-nut hardware are ordered separately, and you need a set at each end where the fitting meets a straight section. Order splice plates matching the same B-Line series and aluminum material so the hole pattern and the metal line up.

Order Eaton B-Line part number 4A-24-60VI24. That covers the aluminum Series 2-5 vertical inside bend, 4 inch height, 24 inch width, 60 degree angle, 24 inch radius. Distributors should quote against that MPN, as width, angle, and radius all change the number.