B-Line Eaton series imperial cable tray and ladder, 6" Height, 27.000" Length, 6" Width, Series 2-5 vertical outside bend, Aluminum, 90° Angle, 24" Ra

A vertical outside bend carries the tray run up and over an obstruction, with the cables riding on the outside of the curve. Eaton B-Line model 6A-06-90VO24 is a 90 degree vertical outside bend for 6 inch wide, 6 inch height Series 2-5 aluminum tray. If the run needs to drop and the cables ride the inside of the curve instead, that is a vertical inside bend, which is a different fitting. Pick by which way the tray face turns, not just by the direction of travel.

The 6A-06-90VO24 fitting is aluminum. Aluminum tray is the usual pick where weight and corrosion resistance matter, including outdoor runs, wastewater, and coastal plants, and it avoids the coating touch-up that cut or drilled galvanized steel needs. Where you need higher load capacity over long support spans, steel tray is the alternative.

The fitting is UL Classified. Aluminum cable tray systems are commonly UL Classified for use as an equipment grounding conductor when the sections and fittings are bonded per the manufacturer's instructions and NEC Article 392. Confirm the specific classification marking on the part against your inspector's requirement before you rely on the tray for grounding.

What ships is the bend itself, model 6A-06-90VO24, a 90 degree Series 2-5 vertical outside bend. Splice plates, bolts, and supports are ordered separately, so plan on a set of splices for each end of the fitting plus hangers at the spacing your run calls for.

It weighs 11 lb, so it is a one-man lift on a ladder or lift. That weight is the fitting alone, before the cable fill it will carry, so size your hangers and trapeze supports for the loaded run and not for the fitting.

Call it out as Eaton B-Line 6A-06-90VO24: 6 inch width, 6 inch rail height, aluminum, Series 2-5 vertical outside bend, 90 degrees, 24 inch radius. That string covers everything an approver checks on the drawing.