B-Line Eaton series JIC panel enclosure, 10" height, 4" length, 8" width, 4X, Hinged cover, 4XACHC enclosure, Wall mount, Small single door, External

The 1084-4XACHC carries a NEMA 4X rating, so it is built for wet, outdoor and corrosive-duty locations including hose-down and washdown areas. The 4X designation is what separates it from a plain NEMA 4 box: the aluminum body and the seamless poured in-place gasket are what deliver the corrosion resistance. It is also UL 50 listed.

It measures 10 inches high, 8 inches wide and 4 inches deep. That 4 inch depth is the number to check first, because it sets how much room you have behind the door for breakers, terminal blocks or a small drive once a back panel is fitted. Weight is 3.2 lb.

The enclosure itself is supplied with panel mounting provisions, meaning the studs or brackets to accept an inner back panel are in the box, but the panel is a separate order. Plan on specifying the matching 10 x 8 back panel with the enclosure if you intend to mount components rather than land conductors directly.

It is a wall mount box with external mounting feet, so the lag or machine screws land outside the sealed cavity. No holes are drilled through the enclosure wall, which is what keeps the NEMA 4X integrity intact after install. Weighing 3.2 lb, it does not need unistrut backing on most solid walls.

This one is the hinged version, with a continuous piano hinge and stainless steel door clamps. Go hinged where the door gets opened regularly for troubleshooting or resets, since the cover stays captive and cannot be dropped or lost. A screw cover box makes more sense for a sealed junction point you open once a year. The clamps are what pull the door into the gasket, so they get tool-free quarter turns rather than a dozen screws.

Aluminum, 14 gauge. Aluminum is the reason this suits coastal, food plant and chemical exposure where a painted steel box would eventually bleed rust at the hinge and clamp points, and it keeps the box at 3.2 lb for one-man installs overhead.

The catalog number is 1084-4XACHC. The digits read as the size, 10 inches by 8 inches by 4 inches deep, followed by the 4XACHC series designation for the NEMA 4X aluminum continuous hinge cover box. It is made in the US.

The body is 14 gauge aluminum and takes hubs cleanly, but the NEMA 4X rating only holds if every penetration uses a watertight hub or fitting rated 4X itself. The enclosure ships with no knockouts to worry about, and the seal at the door comes from a seamless poured in-place gasket, so the door side is not your risk, your field-cut holes are.