B-Line Eaton series JIC panel enclosure, 6" height, 4" length, 6" width, 4X, Hinged cover, 4XSS6CHC enclosure, Wall mount, Small single door, Externa

It carries a NEMA 4X rating and is built from 316 stainless steel, which is the grade used where chlorides and salt spray are a factor, so food processing washdown bays, coastal sites and chemical areas are the intended environments. The seal is a seamless poured in-place gasket rather than a cut strip, so there is no joint at the corners to leak. Door clamps are stainless as well.

6 inches high, 6 inches wide and 4 inches deep, weighing 3.9 lb. That 4 inch depth is what decides whether your breaker, relay or terminal block stack clears the door once it is mounted on the back panel, so measure your deepest component plus wiring bend space before committing.

The box includes panel mounting provisions, meaning the studs or brackets to accept an inner mounting panel, but the panel itself is a separate order. Plan on buying a matching sub-panel if you intend to mount components rather than just splice.

It mounts to a wall using external mounting feet, so all fasteners stay outside the sealed volume. That is the point of feet on a 4X box: drilling through the back wall would defeat the watertight rating. Bolt the feet to the structure and the enclosure interior stays intact.

This one is the hinged version. It uses a continuous piano hinge with stainless door clamps, so the door stays captive and swings clear instead of coming off in your hand on a ladder. A screw-cover box seals the same way but costs you time on every service call and risks lost screws. For a splice you touch once, screw cover is fine; for anything you troubleshoot, take the hinge.

It is built to UL 50, the standard covering enclosures for electrical equipment, and it is manufactured in the United States. That matters on public and institutional work where domestic sourcing is written into the spec.

No. Like other NEMA 4X stainless boxes it ships with no holes, because any factory opening would compromise the watertight rating. You drill or punch your own entries and finish them with 4X rated hub fittings or sealing locknuts to keep the rating intact. Enter the bottom or side rather than the top wherever you can.

Order Eaton B-Line 664-4XSS6CHC. The enclosure itself is the 4XSS6CHC model, a small single-door wall-mount box in the JIC panel series.

16 gauge throughout, in 316 stainless. That is the standard body thickness for a small wall-mount industrial box of this size and it will hold its shape under clamp pressure so the gasket compresses evenly. Finish is a #4 brushed.