B-Line N3030P Eaton series panel enclosure, NEMA 3R, ANSI 61 gray painted, Protects against rain, sleet and ice formation, Galvanized steel, Wall mounting, Panel enclosures, Type 3r large continuous hinge cover, 30" X 30" panel

Yes. The N3030P is a NEMA 3R rated enclosure, which means it protects the equipment inside against rain, sleet and ice formation. That covers outdoor wall mounting on a building exterior, a utility yard, or a pump or pole location. NEMA 3R does not cover hosedown, dust-tight or corrosive-duty service, so for a washdown area or a coastal corrosive environment you want a 4X stainless or non-metallic enclosure instead.

It is built for a 30 x 30 inch panel. The mounting panel itself measures 26.87 inches high by 26.87 inches wide, with a length/depth figure of 26.875 inches, so lay out your devices and wireways inside that usable footprint rather than the nominal 30 inch box dimension.

It carries a UL Listed mark along with its NEMA 3R rating, which is what an AHJ or a facility engineer will look for on an exterior control or distribution enclosure.

It is a wall mount enclosure. No stand or rack is part of it, so plan on a structural wall, strut rack or backboard capable of carrying it. The unit is listed at 22.09 lb before you add the panel and devices, so size your anchors for the loaded weight, not the empty weight.

The N3030P uses a Type 3R large continuous hinge cover, so the door swings on a full length hinge rather than lifting off. A tech can open it one handed at the top of a ladder without setting a loose cover down, and the hinge runs the full door height so a large cover on a 30 inch box does not sag or rack over years of service.

Galvanized steel with an ANSI 61 gray painted finish. The zinc coating plus paint is the standard combination for general outdoor and industrial exposure, and ANSI 61 gray matches the finish on most switchgear and control panels, so it will not look out of place next to existing gear on a facility wall.

The N3030P is sold as the panel enclosure sized for a 30 x 30 inch panel, with the Type 3R large continuous hinge cover as part of it. Order your back panel, conduit hubs and any terminal or din rail hardware separately as the job requires.

Order it as Eaton B-Line N3030P. That single model number covers the NEMA 3R wall mount panel enclosure in ANSI 61 gray with the large continuous hinge cover, so repeat orders for other buildings land on the same box and cover.