B-Line B24KO6-120GRN Eaton series strut channel, 1.62" channel height, 120" channel length, 1.62" channel width, Steel, 14 Gauge, K06 Hole pattern, B24 channel type, DURA GREEN

Yes, if they're 1-5/8 inch strut hardware. The channel opening is on the 1.62 inch square profile, which is the standard 1-5/8 strut size, so ordinary 1-5/8 channel nuts, beam clamps, post bases and conduit straps engage the return lips. Hardware sized for 13/16 inch (half-height) strut will not hold in it.

The B24 channel is punched, not solid, with the K06 hole pattern. That gives you fixed holes to bolt through along the run rather than continuous slots, so layout follows the punch spacing. If your job needs infinite adjustment along the length, you want a continuous-slot channel instead of a K-pattern punch.

DURA GREEN is Eaton B-Line's green coating over the 14 gauge steel channel. It's a coated carbon steel product, not stainless and not hot-dip galvanized, so treat it as a dry or sheltered interior application unless your spec specifically approves a coated-steel strut for the exposure. For wet, corrosive or exterior runs, specify a hot-dip galvanized or stainless strut instead.

At 14 gauge the B24 channel is the lighter-duty steel section, which is what most electricians use for conduit racks, cable tray supports, small pipe hangers and equipment mounting. Where the load is heavy pipe, large tray runs or seismic bracing, step up to a 12 gauge 1-5/8 channel rather than doubling up 14 gauge.

Order Eaton B-Line B24KO6-120GRN. That single number carries the B24 channel type, K06 punch, 120 inch length and the DURA GREEN finish, so no separate finish or length suffix is needed.

No certification is carried on the B24KO6-120GRN strut channel; the record lists certifications as Not Applicable. If your submittal requires a listed support component, specify a channel that is explicitly listed for that use.