B-Line B267RHDG Eaton series strut fittings and accessories, 2.06" Height, 3.5" Length, 1.62" Width, .54lbs, Steel, Right hand three hole single corner wing fitting, Hot-dipped galvanized

The B267RHDG is the right hand version of the three hole single corner wing fitting. Handing matters on wing fittings because the offset wing only bolts up correctly in one orientation, so if your connection mirrors to the other side you need the left hand part instead, not this one. Order the right hand only where the wing sits to the right of the corner as you face the strut run.

The finish is hot-dipped galvanized steel, which is the finish specified for outdoor, damp, and corrosive-atmosphere strut runs. That makes it suitable for rooftop mechanical supports, exterior conduit racks, parking structures, and wash-down areas where a plain or electro-zinc fitting would rust out. Pair it with hot-dipped galvanized channel and hardware so you are not mixing finishes in the same connection.

Three. It's a three hole fitting, so a complete connection takes three channel nuts and three bolts of the length suited to your strut and fitting stack-up. The hardware is not part of the fitting itself, so add channel nuts, bolts, and washers to the order in hot-dipped galvanized to match the fitting's finish.

It braces a corner joint between two pieces of strut channel, carrying the load around the angle instead of relying on the bolted butt joint alone. The B267RHDG is the single wing form, meaning one offset wing off the corner rather than a double, and it is used where the bracing only needs to pick up one plane of the connection. In galvanized steel it's typical on exterior conduit racks, pipe supports, and equipment frames.

B267RHDG, from Eaton's B-Line series of strut fittings and accessories. The DG suffix on the number is the hot-dipped galvanized finish designation, which is how you tell it from the same fitting in a plain or zinc finish when you are matching what is already installed.