B-Line Eaton series strut fittings and accessories, 3.93" Height, 1.87" Length, 1.62" Width, .56lbs, Steel, Three hole corner angle, 90 deg, DURA GREE

DURA GREEN is B-Line's painted green coating over steel, which is a general-purpose indoor finish for strut and fittings. No corrosion rating or outdoor listing is carried for the B232GRN, so for exterior, damp, or wash-down work specify a hot dip galvanized or stainless version of the same corner angle rather than the green painted one.

No. The B232GRN ships as the steel angle only. You order the hardware separately, normally a 1/2 inch strut nut and hex bolt set per hole, three sets to fill all three holes on a corner.

Order Eaton B-Line part B232GRN. The GRN suffix is the DURA GREEN painted steel version of the three hole 90 degree corner angle; the same fitting exists in other finishes under different suffixes, so keep the GRN if you are matching an existing green strut system.

The B232GRN is a three hole 90 degree corner angle for Eaton B-Line strut. It bolts across the joint where two lengths of strut meet at a right angle, so the fitting carries the corner instead of relying on the strut ends alone. Three bolt holes total across the two legs, in steel with a DURA GREEN finish.

No certification is carried on the B232GRN corner angle. It is a mechanical support fitting, so if your submittal requires a listed or third-party certified support component, this one will not satisfy that line item.

They do different jobs. A flat 90 degree plate lies on one face of the strut and ties two pieces in the same plane. The B232GRN is a corner angle, bent to 90 degrees, so it wraps the corner and picks up both pieces on their own faces, which is what you want where one strut turns up or away from the other. For flat, in-plane joints stay with a flat plate.