B-Line B115PAGRN Eaton series strut fittings and accessories, 3.93" Height, 3.75" Length, 1.62" Width, .76lbs, Steel, Pre-assembled fitting, Four hole adjustable corner angle, 90 deg, pre assembled, Thickness 1/4 in, DURA GREEN

The B115PAGRN is a four hole adjustable corner angle for strut channel, set at 90 degrees and shipped pre-assembled. It joins two runs of strut at a right angle, with two bolt holes into each leg, so you get a four bolt connection at the corner of a frame, support rack or trapeze. Because it arrives pre-assembled, the angle and its hardware go up as one piece instead of being built on the lift.

It is steel at 1/4 inch thickness, which is the heavy end of strut fitting stock rather than formed light-gauge sheet. That matters if you are hanging pipe, cable tray or equipment loads off the corner rather than just squaring up a light frame.

The B115PAGRN is supplied as a pre-assembled fitting, so the angle arrives made up rather than as loose plates. Plan your order around the channel nuts and bolts needed to fasten it into the strut itself, along with the strut lengths and end caps, since those are separate line items on a strut job.

One B115PAGRN handles the corner on its own: it is a four hole angle, two holes per leg, so each leg of the strut gets a two bolt connection rather than a single pivot point. For heavier loads or where the frame will be racked sideways, installers commonly double up with a fitting on each face of the channel.

DURA GREEN is Eaton B-Line's coated finish for the steel fitting, used where plain electro-zinc is not enough, such as damp mechanical rooms, wash-down areas and covered exterior work. If the rest of your strut run is plain zinc, order the matching fittings in the same finish so you are not mixing coatings at the bolted joint.

No certification is carried on the B115PAGRN corner angle; the record lists certifications as not applicable. It is a mechanical support fitting, so on a job where the inspector is looking for a listing, that requirement sits with the system components it supports, not with the angle.

Order it as B115PAGRN from Eaton B-Line. That single part number covers the pre-assembled four hole adjustable corner angle in the DURA GREEN finish; there is no separate finish or size suffix to specify.