B-Line B409-24SS4 Eaton series strut fittings and accessories, 4.62" Height, 24" Length, 1.62" Width, 4.50lbs, Steel, Single channel bracket, Uniform load capacity 480 lbs, Stainless steel type 304

The B409-24SS4 single channel bracket carries a uniform load rating of 480 lbs. That is a uniform distributed load across the 24 inch run, not a point load hung off the free end, so keep supported equipment spread along the channel rather than concentrated at the tip.

It is type 304 stainless, which is the usual choice for exterior runs, damp mechanical rooms, food processing and wash-down areas where plain or electro-galvanized strut fittings would rust out. For heavy chloride exposure such as coastal or pool chemical environments, a 316 fitting is the better call.

Yes. At 1.62 inches wide it matches the 1-5/8 inch profile that standard strut channel and strut fittings are built to, so it lines up with common channel nuts and hardware in that series.

Measures 4.62 x 24 x 1.62 inches (height, length, width) and weighs 4.5 lbs. The 24 inch dimension is the channel run, so plan your wall-to-equipment projection and your clearance behind the mounted gear around that figure.

Plan on it. The B409-24SS4 is the bracket alone. Anchors into the wall or structure, plus the channel nuts and bolts that clamp your equipment or conduit to the bracket, are separate items. In a stainless install, match the fasteners to the bracket in 304 or better so you do not set up galvanic corrosion at the connection.

A single channel bracket like the B409-24SS4 is one run of channel, 24 inches long here, for hanging conduit, boxes, or light equipment off a wall or structure. A double channel version pairs two channels back to back for greater stiffness and higher load over the same span. If 480 lbs uniform covers your load, the single is the lighter and shallower option at 4.5 lbs.

Order Eaton B-Line B409-24SS4. The SS4 suffix is the type 304 stainless version, and the 24 in the number is the 24 inch channel length.