B-Line Eaton series strut pipe clamps and accessories, .059" height, 2.501" length, 1.25" width, Steel, Include combination recess hex head machine sc

The B2002SS6 is a Type 316 stainless steel strut pipe clamp part. Type 316 is the grade you want for wash-down areas, coastal or marine exposure, chemical plants and food processing, where plain or electro-galvanized steel pits out. If your run is indoor and dry, a cheaper plated carbon steel clamp will do the same mechanical job.

The screw is included. The B2002SS6 ships with a combination recess hex head machine screw, so you get the clamp and its fastener in one part number. The combination head means you can drive it with a hex driver or a screwdriver, which matters on a lift or in a ceiling grid where you may only have one tool on you.

Mechanically yes, it bolts to standard strut the same way. But be deliberate about it: pairing 316 stainless hardware with plain galvanized channel in a wet or coastal location puts two dissimilar metals in contact, and the galvanized channel is the one that gives up first. If you are specifying 316 because of the environment, run 316 strut and 316 channel nuts with it.

Order it as Eaton B-Line B2002SS6. The SS6 suffix is the Type 316 stainless version of the B2002 clamp, so if a submittal just says B2002 and the environment is corrosive, SS6 is the suffix you want to call out.

It measures .059 x 2.501 x 1.25 inches (height, length/depth, width as published) and weighs .11 lb each. That .059 inch figure is the strap thickness, so it seats flat against the strut face without spacing the pipe off the channel. The low unit weight matters when you are ordering by the hundred for a long overhead run.

No agency certifications apply to this clamp; the certification field reads Not Applicable. If your job spec calls for a listed support component, check the spec language before you commit, because this part is supplied as a plain mechanical pipe clamp.