B-Line Eaton series strut pipe clamps and accessories, .074" height, 2.951" length, 1.25" width, Steel, Pre-assembled combination recess hex head scre

The B2010PASS4 clamp is a stainless steel type 304 strut pipe clamp. The catalog material field lists it as steel, and the product detail calls out stainless steel type 304, which is what makes it suitable for damp, washdown, or corrosive runs where a plain electro-galvanized clamp would rust out.

It ships as a pre-assembled unit with a combination recess hex head screw already fitted, so the fastener is not a separate line item. The recess head lets you drive it with either a hex driver or a screwdriver bit, which matters when you are running a long rack of clamps overhead and want to stay on one tool.

The clamp measures .074 x 2.951 x 1.25 inches (height, length, width as listed) and weighs .16 lb. That 2.951 inch length is the figure to check against your strut channel spacing and the outside diameter of the pipe or conduit you are strapping, and the light weight keeps the load on a long horizontal run down to the pipe itself.

Yes. It is catalogued by Eaton as a pipe or conduit clamp, so it is intended to strap either piping or electrical conduit to strut channel. Contractors commonly use the same clamp family for EMT, IMC, and rigid runs racked on channel. Match the clamp size to the actual outside diameter of the conduit trade size you are running rather than the trade size alone.

Corrosion is the whole reason. A galvanized clamp relies on a zinc coating that gets scratched during install and eventually gives up in coastal air, rooftop weather, or a washdown environment. Type 304 stainless carries its corrosion resistance through the base metal, so the B2010PASS4 holds up on exterior racks, mechanical rooms, food processing, and water treatment work. For a dry indoor office fit-out, a plain steel clamp is the usual call and stainless is more than the job needs.

Order it as Eaton B-Line B2010PASS4. That is the manufacturer part number for the pre-assembled 304 stainless strut pipe clamp, and it is the only configuration offered under that number, so there is no finish or size suffix to add.

Eaton lists certifications as not applicable for this clamp, so specify it as a mechanical support component rather than as a listed electrical device. On jobs where the inspector is looking for listed supports, confirm the requirement against your spec section before locking in the submittal.