B-Line Eaton series strut pipe clamps and accessories, .0966" height, 5.039" length, 1.25" width, Steel, Includes combination recess hex head machine

The B2014YZN ships with a combination recess hex head machine screw included, so the clamp and its fastener come together. You still need the strut channel nut or the channel itself if you are building the run from scratch, but the screw that closes the clamp is in the box.

Yellow zinc chromate over steel is a plated coating for indoor and sheltered service. It handles the humidity of a mechanical room, boiler room, or parking structure interior fine, but it is not a hot dip galvanized or stainless product, so for direct outdoor exposure, roof runs, or coastal air a buyer should step up to a galvanized or stainless clamp instead.

The clamp measures .0966 x 5.039 x 1.25 inches and weighs .38 lb. That 5.039 inch dimension is the overall strap length, so allow for it plus the pipe diameter when you are working between a deck and a ceiling grid. It is a flat strap style clamp, not a bulky two-piece body, so it sits close to the channel face.

Yes. The B2014YZN is catalogued as a pipe or conduit clamp, so it is intended for both piping and electrical conduit runs mounted to strut channel. Contractors use the same clamp family for EMT, rigid conduit, and small process or water lines on a shared trapeze.

Order it as Eaton B-Line B2014YZN. The YZN suffix is the yellow zinc chromate finish, and the clamp is supplied in steel with its machine screw. That is the full manufacturer part number a distributor or counter will need.

No listing or certification is carried on the B2014YZN clamp record, so treat it as a standard steel strut clamp rather than a listed assembly component. Where a project spec calls for a listed support, confirm the requirement against the strut and hanger system as a whole.