B-Line Eaton series Type 1 junction boxes, 30" height, 12" length, 24" width, 1, Screw cover, SCGV NK enclosure, Surface mounted, Medium single door,

No. The 302412 SCGV NK carries a NEMA Type 1 rating, which is indoor use only, for protection against incidental contact and falling dirt. It offers no protection against rain, hose-down, dust ingress or corrosive liquids. For a wet or outdoor location you need a Type 3R or Type 4 enclosure instead.

It measures 30 inches high, 24 inches wide and 12 inches deep, so plan for a 30 x 24 footprint on the wall plus clearance to swing or lift the screw cover clear. The box weighs 52.1 lb empty, which is a two-person lift and means the mounting substrate needs to take real load.

No knockouts. The NK in the model designation means the box ships blank, so every conduit entry gets punched or hole-sawed on site where you want it. That is the usual choice on a pull or junction box when the conduit layout is set in the field, but it does mean budgeting time for hole punching and the right connectors and sealing washers.

It is built to UL 50, the standard covering enclosures for electrical equipment, and it is a US-made product. That plus the NEMA Type 1 designation is normally what a submittal for an indoor pull or junction box asks for.

It is a surface-mount enclosure with thru holes in the back for fastening straight to the wall or to strut. Pick fasteners rated for the substrate and the 52.1 lb empty weight plus whatever wiring and devices go inside. The cover also has keyhole slots, so it hangs on partially backed-out screws while you line up the rest.

Screw cover, not hinged. It lifts completely off, which gives full access to the interior for pulling and landing conductors but means you need a clear spot to set the panel down and a place to keep the plated screws. Keyhole slots on the cover let you hang it on the screws before tightening, which helps on a box this size. If crews open the box often, a hinged-door enclosure is the easier choice.

The body is galvanized steel supplied unfinished in a grey appearance, so no paint is required and none is applied. The galvanizing handles ordinary indoor humidity, plant and mechanical-room conditions. It is not a substitute for a higher NEMA rating in a wet or corrosive space, and paint will not change that either.

Body is 14 gauge galvanized steel. At 30 x 24 x 12 inches that wall thickness keeps the box from oil-canning when you punch conduit entries and lets it carry mounted terminal blocks and wire management inside rather than acting purely as a pull point.

Order Eaton B-Line 302412 SCGV NK. The number reads straight off the size: 30 inch height, 24 inch width, 12 inch depth, screw cover galvanized, no knockouts.