B-Line Eaton series Type 1 junction boxes, 36" height, 10" length, 24" width, 1, Screw cover, SC NK enclosure, Surface mounted, Medium single door, N

No. It carries a NEMA Type 1 rating, which is indoor, dry-location only, for protection against incidental contact and falling dirt. It gives no protection against rain, hose-down, dust ingress, or oil. For a wet or outdoor pull box you need a NEMA 3R, 4, or 4X enclosure instead.

It measures 36 inches high, 24 inches wide, and 10 inches deep, which is where the 362410 designation comes from. Plan your wall space for the full 36 x 24 face plus clearance to swing or lift the screw cover off, since the cover comes fully away rather than hinging.

No knockouts. The 362410 SC NK is supplied blank, so every conduit entry is punched or drilled in the field wherever your raceway lands. That is an advantage on a custom layout and extra labor if you wanted pre-located hubs. The steel is 14 gauge, so plan on a proper knockout punch rather than a step bit for larger trade sizes.

Surface mounting, using thru holes in the back of the box, so it fastens flat against a wall or strut with your own anchors or bolts. Fasteners are not part of the box, so pick them for your substrate. At 63.3 lb empty it is a two-person lift and it needs to land on structure or a Unistrut frame, not drywall anchors alone. The cover also has keyhole slots, which let you hang it on partially driven screws while you start the rest.

A screw cover box like the 362410 SC NK has a removable cover fastened with plated screws, meant for wiring pull points, splices, and gutters you open rarely. A hinged door enclosure is the choice where you need frequent access to devices, terminal blocks, or controls inside. If the box will be opened for routine maintenance or troubleshooting, go hinged; for a splice or pull point behind a panel run, the screw cover is the simpler and more secure option.

It is built to UL 50, the standard covering enclosures for electrical equipment. That, with the Type 1 rating, is what an inspector looks for on an indoor pull or junction box. It is also made in the US, which matters on work carrying domestic sourcing requirements.

Painted carbon steel in ANSI 61 grey, the standard light grey used across most industrial panelboards, control cabinets, and gutters. Lined up next to other ANSI 61 equipment it reads as a match. Being painted steel rather than stainless, keep it out of damp or corrosive rooms where the finish will rust at field-punched openings.

Yes, 14 gauge is the usual body thickness for commercial screw cover boxes in this size range, and on a 36 x 24 x 10 box it keeps the walls from oil-canning when you pull conductors or hang the box off strut. It also means field openings hold their shape around conduit hubs and locknuts.