B-Line Eaton series Type 1 junction boxes, 6" height, 3" length, 6" width, 1, Screw cover, SCGV enclosure, Surface mounted, Small single door, 3 knoc

No. The 663 SCGV carries a NEMA Type 1 rating, which is indoor use only, for protection against incidental contact and falling dirt. It has no gasket and no watertight seal, so keep it out of wet locations, exterior walls, and anywhere subject to hosedown or dripping. For those areas you need a NEMA 3R or 4 enclosure instead.

It is a 6 x 6 x 3 inch box: 6 inch height, 6 inch width, and 3 inch length/depth. That 3 inch depth gives room for splices and wire nuts on branch circuits, and the 6 x 6 face matches standard pull and junction box sizing. Shipping weight is 2.7 lb.

The 663 SCGV is listed to UL 50, the standard covering enclosures for electrical equipment. It is also made in the US.

Twelve total: 3 knockouts on each side, 3 on the top, and 3 on the bottom. That lets you bring conduit or cable in from four directions without drilling, which is what makes it workable as a mid-run pull point rather than just a dead-end splice box.

The cover is a screw cover with plated screws, so it is fully removable rather than hinged, and it has keyhole slots so you can loosen the screws and lift the cover off without backing them all the way out. The box itself surface mounts through thru holes in the back, meaning you fasten it directly to the wall or structure with your own anchors or screws, which are not supplied.

Body is 16 gauge galvanized steel, left unfinished in a gray appearance. The zinc coating gives it reasonable resistance to humidity and condensation in an indoor mechanical or utility space, but it is not a painted or coated exterior enclosure and it should not be used where it gets wet.

It ships unfinished galvanized, gray in appearance, so there is no factory paint to match against. Galvanized steel takes paint only with a suitable primer. If the box is going in a finished area, plan on prep, or locate it above ceiling or in a utility space instead.