B-Line Eaton series wall mounted panel enclosure, 48" height, 10" length, 30" width, 4, Hinged cover, 4 enclosure, Wall mount, Medium single door, Ex

The 483010-4 carries a NEMA 4 rating, so it is built for indoor or outdoor use against windblown dust, rain, splashing water and hose-directed water. It gets that with a seamless poured in-place gasket and stainless door clamps around a hinged cover. It is not a NEMA 4X enclosure, so for corrosive or salt-laden environments you want a stainless or non-metallic 4X body instead of this painted carbon steel one.

48 inches high, 30 inches wide, 10 inches deep. That 10 inch depth is the number to check first if you are stacking a panelboard interior, breakers and wireway inside, since deep-body gear and large bending radius wire can eat it up fast.

It weighs 104.7 lb empty. That is a two-person lift, or a lift with mechanical help, and the wall has to carry it plus whatever gear goes inside. It mounts with external mounting feet, so plan your anchors into studs, unistrut or masonry rather than drywall alone.

Yes. The 483010-4 uses external mounting feet, so the bolt holes sit outside the enclosure body and you never drill through a sealed wall to hang it. That is what keeps the NEMA 4 seal intact after installation, unlike back-mounted boxes where the hardware penetrates the enclosure.

The 483010-4 has a padlock provision on the hinged door, so it will take a standard shackle for lockout/tagout or general security. The door is held closed with stainless clamps, which is what compresses the gasket for the NEMA 4 seal; the padlock is for restricting access, not for sealing.

It is the enclosure body and hinged door only. Panel enclosures of this style are ordered with the back panel separately, sized to the 48 x 30 box, so add a subpanel and its mounting hardware to the order if you plan to mount gear inside rather than land it on the enclosure wall.

It is built to UL 50, the standard covering enclosures for electrical equipment. Pair that with the NEMA 4 rating when you are writing it into a submittal for a washdown or outdoor location.

Only with watertight fittings. The 483010-4 ships as a sealed body with a poured in-place gasket, and any hole you punch has to be closed with a NEMA 4 rated hub or watertight connector or you lose the rating at that penetration. Entries into the top face are the ones most likely to cause trouble on a hose-down or outdoor install.

14 gauge carbon steel, painted ANSI 61 grey. ANSI 61 is the standard grey used across most industrial control gear, so it matches typical switchgear and control panels already on the wall.

Order it as Eaton B-Line 483010-4. The number reads out as the size: 48 high, 30 wide, 10 deep, type 4. Country of origin is the US.