B-Line Eaton series wireway, 8" height, 36" length, 8" width, HS wireway, Thru holes, 11 top knockouts, 11 bottom knockouts, Hinged cover, 1, Steel,

No. It's a NEMA 1 enclosure, which is indoor, general purpose only. It protects personnel from contact with the enclosed wiring and keeps out falling dirt, but it is not sealed against rain, washdown, or dust. For an outdoor feeder run you need a NEMA 3R raintight wireway instead.

Yes, 11 knockouts on the top and 11 on the bottom of the 36 inch section, so you can land conduit runs entering and leaving without drilling the enclosure. The sides and ends are not described as knockout punched, so plan side entries as field work.

The cover is hinged, so it swings open along one side for pulling conductors and stays attached to the body. Plated screws secure the cover to the body, so you back those out to open it. Compared with a screw cover wireway where the whole lid lifts free, the hinged style means one person can open a long run without setting loose covers down on the floor.

Mounting is through holes in the body, so it fastens directly to a wall, strut, or backpan with your own hardware. Fasteners and struts are not part of the wireway, so size them for the run. At 21.163 lb per 36 inch section empty, plus conductor weight, plan supports accordingly.

It carries CSA C22.2 certification, so it is acceptable for Canadian installations as well as US work. Cite the model number 8836 HS on submittals when the inspector wants the certification confirmed.

14 gauge steel, finished in ANSI 61 gray. That's the standard gray used on most switchgear and panelboards, so a run of this wireway matches adjacent electrical equipment in a mechanical or electrical room without repainting.