You may also like
Eye Bolt 7/16 X 10 Eye Blt &Nt St-zn (Box 10)
Manufacturer Resources
Product Specs
- Division:
- Electrical H1
- Pack Type:
- Box
- Product Group:
- Fasteners
- Sub Division:
- Electrical-E H2
- Department:
- Electrical
- Product Subgroup:
- Bolts
Metallics EB10 – Frequently Asked Questions
1) Is the EB10 a welded or forged eye bolt, and can I use it for overhead lifting?
Do not treat the EB10 as rigging hardware. It is a zinc plated steel eye bolt and nut sold for electrical fastening and support work, with no lifting rating behind it. Overhead lifting calls for a forged, load-rated shoulder eye bolt with a published working load limit.
2) How many eye bolts are in a box of Metallics EB10?
The EB10 is sold as a box of 10 eye bolts with nuts, so it is a bulk pack rather than a single piece. If you only need one or two for a hanging point, plan on the leftovers going to stock.
3) Is the zinc plated finish on the EB10 eye bolt okay for outdoor or damp locations?
Zinc plating gives the steel EB10 moderate corrosion resistance, which suits dry interior and sheltered work. For sustained wet exposure, coastal air, or wash-down areas, zinc plated steel will eventually rust at the threads and eye; stainless is the better call there.
4) What thread does a 7/16 eye bolt take, and will standard 7/16 hardware fit it?
At 7/16 inch diameter the EB10 takes standard 7/16 inch hardware, and the matching nut is included in the box. A 7/16 washer under the nut is worth adding when you are bolting through sheet metal or wood, since it spreads the load; washers are not part of this pack.
5) Can I use a Metallics EB10 eye bolt to hang conduit or support an electrical run?
That is the intended work. The EB10 is an electrical-trade fastener, catalogued by Metallics alongside bolts for support and anchoring, and the 10 inch shank gives you reach through thick members or standoff from a surface before the nut lands. Use it as a hanging or tie-off point for wire, hanger rod assemblies, or support wire, matched to the load your engineer specifies.
6) How thick a beam or wall can a 7/16 x 10 eye bolt go through?
The 10 inch shank is the limit on through-bolting: subtract the eye itself and the nut engagement, and you still have usable grip through members several inches thick, such as doubled framing, timber, or a thick masonry section with a sleeve. For thinner material the extra length just means trimming or accepting the stickout.
How fast can I get the Metallics EB10 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Metallics EB10 come with a warranty?
Absolutely. The Metallics EB10 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Metallics EB10?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Metallics EB10 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.